User`s manual

BHT-825Q series

 “2: DEVICE SETTINGS”: Device settings during reading

1. Use the cursor keys ([▲] [▼]) or numerical keys ([1] [2] [3]) to highlight the

item to be set, highlight the setting value using the cursor keys ([◄] [►])

and press the ENT key.

Press the BS/C key to return to the SET QRCODE menu.

“1: SCAN MODE”

Set the scan mode.

“0”: Normal mode

Codes within the field of view can be read.

Refer to “Chapter 8 Specifications” regarding the size of the field of view.

“1”: Point scan mode

Codes above the cross at the center of the marker can be read. Reading will be unsuccessful if there is

no code above the cross or the marker cannot be detected due to external light. This kind of reading is

only enabled if marker illumination is enabled.

“2: MARKER”

Set whether the guide marker illuminates or not when the trigger switch is pressed.

“0”: Operated by trigger switch

“1”: Locked ON (Illuminates)

“2”: Locked OFF (Doesn’t illuminate)

- Point -

When the marker is locked on, more power is used and operating times are shorter

compared to other modes. Do not change these settings unless necessary.

“3: LIGHT”

Set whether the INDICATOR LED light illuminates or not when the trigger switch is depressed.

“0”: Illuminates

“1”: Illuminates

“2”: OFF