User Manual

• Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi-

tions: (1) This device may not cause harmful interference, and (2) this device must accept any inter-

ference received, including interference that may cause undesired operation.

Company Name: DENSO PRODUCTS AND SERVICES AMERICAS, INC.

Address: 3900 Via Oro Avenue, Long Beach, California 90810, U.S.A.

Telephone: +1-310-834-6352

FCC CAUTION

Any changes or modifications not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment

This transmitter must not be co-located or operated in conjunction with any other antenna or trans-

mitter.

The available scientific evidence does not show that any health problems are associated with using

low power wireless devices. There is no proof, however, that these low power wireless devices are ab-

solutely safe. Low power Wireless devices emit low levels of radio frequency energy (RF) in the micro-

wave range while being used. Whereas high levels of RF can produce health effects (by heating

tissue), exposure of low-level RF that does not produce heating effects causes no known adverse

health effects. Many studies of low-level RF exposures have not found any biological effects. Some

studies have suggested that some biological effects might occur, but such findings have not been

confirmed by additional research. This Handy Terminal has been tested and found to comply with FCC

radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency

(RF)Exposure Guidelines.

This device meets all the other requirements specified in Part 15E, Section 15.407 of the FCC Rules.

FOR PORTABLE DEVICE USAGE (<20 cm from body/SAR needed)

The product complies with the FCC portable RF exposure limit set forth for an uncontrolled environ-

ment and are safe for intended operation as described in this manual. The further RF exposure reduc-

tion can be achieved if the product can be kept as far as possible from the user body or set the device

to lower output power if such function is available.

For body-worn operating conditions please use belt-clips, holsters, and/or accessories that have no

metallic component in the assembly and must provide at least 10 mm for BHT-M70-QWG or 10 mm for

BHT-M70-QW separation between the device and the user's body.

Body-worn accessories that do not meet these requirements may not comply with RF exposure

requirements and should be avoided

FOR COUNTRY CODE SELECTION USAGE (WLAN DEVICES)

Note: The country code selection is for non-US model only and is not available to all US model. Per

FCC regulation, all WiFi product marketed in US must fixed to US operation channels only.

User Steps to Access Information

Starting from Menu or Home:

Step 1 – BHTShell

Step 2 – 5 SystemInfo

Step 3 – 2 Regulatory Info