User`s manual

Barcode Handy Terminal

 Setting the Wireless Options

Tap the Option tab on the NIC Control menu to display the screen shown

at the right.

Power: Wireless module power save mode setting

CAM: Always ON

FastPSP: Power save mode (Default)

− Note − When using the BHT with PSP mode set, set a low value (2

or 3) for DTIM at the access point. It may not be possible to

reconnect to the access point if a larger value is set.

Radio mode:Radio mode setting

11b: Enable 802.11b connection

11b/g: Enable 802.11b or 802.11g connection

11a: Enable 802.11a connection

Controller: Selecting wireless communication control mode

ZeroConfig Windows Zero Configuration networking included in Windows CE

Select this mode to use the supplicant supplied by Microsoft.

This mode hides the Profiles tab displayed at the right of the Option tab.

RF Control BHT-own control

Select this mode to use the supplicant supporting Cisco Compatible Extensions.

This mode displays the Profiles tab to the right of the Option tab. The Profiles window

allows you to configure the settings for BHT-own control (see Section 4.5.2, "Editing in RF

Control").

− Note − After switching between the ZeroConfig and RF Control and making settings, warm-boot the

BHT to make the settings effective.

The Controller setting is available in System Software version 2.xx or later which can be

downloaded for free from our Web site, "QB direct."

Reconnection interval:

Sets the time until another attempt is made to connect

after failing to connect to all wireless networks.

Disable popup dialog:

The Wireless Zero Configuration screen sometimes pops up

when no wireless network connection settings have been

made or when connection to all wireless networks has failed.

Select this check box to prevent this popup screen displaying.

 Editing the Connection Profiles

Refer to Section 4.5.2 "Editing in RF Control."