User`s manual

89
Barcode Handy Terminal
 Performing a Ping test
Tap the “Ping” tabbed page at the NIC Control menu to display the screen
on the right.
Dest IP: Specifies the IP address of the host computer
to be pinged.
Data size: Specifies the data size of the echo request.
Interval: Specifies the length of echo request intervals (in
100 ms units).
Timeout: Specifies the timeout period (in 100ms units) for
the echo request.
Type1 or Type2: Specifies the echo request transmission timing
(described on next page).
Count: Specifies the number of echo requests to be sent.
Tap the [Ping Start] button or press the ENT key to commence the Ping test.
− Note − Tapping the [Ping Start] button when the wireless device is not open automatically opens
the wireless device and commences the Ping test.
Setting ranges
Item Allowable Entry Range Default Value
Data size
1 to 2048 32
Interval 0 to 65535 10
Timeout 0 to 65535 10
Count
0* to 65535 4
* By setting zero (0), the number of echo requests sent will be infinite (until the Ping test is aborted.)
If a value outside the allowable entry range is specified, the nearest value within the range will
automatically be applied.
The screen on the right displays when the Ping test is commenced.
Count: Number of echo requests sent
OK: Number of echo replies
NG: Number of errors that occurred while
performing the Ping test
Timeout: Number of timeouts (for echo requests)
that occurred while performing the Ping test
RTT Ave.(ms): Echo reply time