User`s manual

108
BHT-700BB-CE/700BWB-CE/700BWBG-CE
4.5.2 Editing in RF Control
If Controller is set to RF Control (BHT-own control), make wireless network settings on the Profiles page
(shown at the right) which is called up by tapping the Profiles tab on the Radio Frequency menu screen.
This page provides the following buttons.
Button Use to
• New... Create a new profile.
• Edit... Edit the selected profile.
• Delete Delete the selected profile.
• Up Raise the priority of the selected profile.
• Down Lower the priority of the selected profile.
• Cert... Edit certificates.
• Apply Apply new settings made on this screen.
• Reset Reset new settings made on this screen.
− Note − The Profiles page appears only when Controller is set to RF Control on the Option page.
The above RF control settings are available in System Software version 2.xx or later which
can be downloaded for free from our Web site, "QB direct."
[1] New
On the Profiles page, tapping the New... button displays the screen
shown at the right.
(1) SSID
Enter an ID that identifies the wireless network.
(2) Authentication
Select the authentication method when the encryption method is
selected.
(3) Encryption
Select the encryption method.
(4) Key
Enter the WEP Key when the encryption method is set to WEP. W
the authentication method is set to WPA-PSK, enter the Pre Shared Key.
hen
(5) Key index
Enter the key index (1 to 4).
(6) EAP type
Select the type of 802.1X.
(7) Properties
Configure parameters suitable for the EAP type selected. For details, refer to the following pages.