User`s manual

128
BHT-700BB-CE/700BWB-CE/700BWBG-CE
Mishandling may result in battery cartridge overheating, smoke generation, blowout or
combustion. Please read the following items prior to use.
 Never charge the battery cartridge in the vicinity of fire or under a scorching sun.
 Always use a dedicated charger to charge the battery cartridge.
Mishandling may result in battery cartridge overheating, smoke generation, blowout or
combustion. Please read the following item prior to use.
 Terminate charging if not completed even after the specified time has elapsed.
− Note −  Replace the battery cartridge promptly.
 If the BHT is left for long periods of time with the battery cartridge removed, it may not be
possible to back up the content of the RAM, and data including files and settings stored in the
RAM may be lost. In that case, because the RAM will revert to the factory default, it is
recommended that any important data be backed up to the “FLASH” folder or uploaded to the
host computer. When the BHT turns ON after the data in the RAM is deleted, the BHT starts
from the “Initial Setup”.
 Always turn the BHT power OFF before replacing the battery cartridge. Replace the depleted
battery cartridge with a new one within three minutes to avoid data loss. Following
replacement, turn ON the BHT power and check operation.
 The battery cartridge is charged using either a CU-733/714 communication unit (option) or
CH-751/704 battery charger (option). Refer to “Chapter 9” for details of the charging method
for the CU-733/714. Refer to the respective User’s Manual provided with each device fo
r
details of the charging method for the CH-751/CH-704.
 If a “Replace the battery!” or “Charge the battery!” message displays when impact is applied to
the BHT, reboot the BHT and check the battery voltage level. The battery may not actually be
depleted.