Specifications

Chapter 9 Operating Vision Manager
9-29
(2) Edit by numerical value input
Window edit tool Q Click on in the tool bar.
The window edit tool appears.
R Select a window (A) to be edited.
S Double-click on the cell (B) to change the set value.
Cell characters are displayed in reverse video.
T When you enter a value, it replaces (or is inserted into) the
reversed value.
U Click on Register in the window edit tool.
The set value (B) in the window edit tool is registered to the
window.
(3) Teaching window by key operation
Using the teaching panel, the window shape can be fine-adjusted by
carrying out the following key operations while editing the window shape.
Window type
Name
Illustration Teaching method
WNDDPT
X Start Point Shift Left/Right [→][←]
Y Start Point Shift Up/Down [
↑
][
↓
]
X End Point Shift Left/Right [W][S]
Y End Point Shift Up/Down [H][L]
WNDALN
X Start Point Shift Left/Right [→][←]
Y Start Point Up/Down [
↑
][
↓
]
Length Extend/Reduce [W][S]
Angle Increase/Decrease [B][C]
WNDRCT
X Start Point Shift Left/Right [→][←]
Y Start Point Shift Up/Down [
↑
][
↓
]
Width Increase/Decrease [W][S]
Height Increase/Decrease [H][L]
WNDCIR
X Center Shift Left/Right [→][←]
Y Center Shift Up/Down [
↑
][
↓
]
Radius Increase/Decrease [W][S]
WNDELP
X Center Shift Left/Right [→][←]
Y Center Shift Up/Down [
↑
][
↓
]
Width Increase/Decrease [W][S]
Height Increase/Decrease [H][L]
WNDSCT
X Center Shift Left/Right [→][←]
Y Center Shift Up/Down [
↑
][
↓
]
Inside Diameter Increase/Decrease [W][S]
Outside Diameter Increase/Decrease [H][L]
Starting Angle Increase/Decrease [B][C]
Ending Angle Increase/Decrease [M][N]
S
traight line
Rectangle
Circular arcPerimeter
Elliptic perimeter
End point
Start point
r: Radius
Width
Start point
Height
End
XR
XR: Width
YR: Height
λ: Outside Diameter
r: Inside Diameter
θ1: Starting Angle
θ2: Ending Angle
Circular Arc
YR
A
B
Start point