Specifications

10-32
10.7.4 StartLog
After execution of StartLog, if the
ring buffer becomes full, the
process will be stopped.
That is, the log of process from
StartLog to the full buffer state
can be fetched.
10.7.5 Stoplog
The current ring buffer can be
stoped at the same time as
StopLog.
10.7.6 ClearLog
Restarts the ring buffer.
Restarts the sampling process which has been stopped with StartLog or
StopLog.
10.7.7 Saving or Deleting Control Log to/from the Flash Area
If the control log cannot be immediately read in WINCAPSII, then use this
function to take a backup.
Control log preserved in the flash memory is secured even after the power
supply of the controller is cut off.
You may save control log from the teach pendant or operating panel. Deletion
of control log is possible only from the teach pendant.
NOTE: There may be changes of failure in save process due to insufficient
flash memory.
NOTE: If you save control log again after saving it, the log data will be
overwritten.
Buffer
Time
StartLog command
Log is recorded
here.