Specifications

Chapter 2 Setting Personal Computer Teaching System
2-37
"
STEP 7
Select IP Address tab and click to specify an IP address. Then input
required data in IP Address and Subnet Mask.
For the actual values of the IP address and subnet address, inquire to the
network administrator in charge of the pertinent network.
If the network is local (for example, an environment for connecting the
personal computer and the robot controller only), the IP address can be set
as desired. Therefore, the IP address will be tentatively set here to
192.168.0.1 and the subnet address to 255.255.255.0.
Click on OK and the IP address setting is completed.
Note (1): When making connection to a wide area network (for
example an in-house network), always inquire to the
network administrator before setting the IP address and
subnet mask.
If an IP address used for the local area network is
connected to the wide area network (for example the in-
house network) without first invalidating it, confusion
may be occur in the connected network.
Note (2): No redundant IP addresses are allowed within the same
network. When making a connection to a widely shared
network, care should be taken not to allow an IP address
to be redundant with another terminal. The following are
examples of IP addresses that have the least probability
of redundancy with another terminal:
192.168.0.2 to 192.168.0.xxx (xxx represent 003 to 999.)