Instructions

MDA-250
Wooden CD/DAB Music Centre
Quick Start Guide
2
Switching Your Unit On For The First Time
1. Fully extend the wire antenna and plug it into the ANT socket.
2. Connect the AC Mains cable to the appropriated AC mains socket.
3. Press the /Mode button once to turn the system on, it will automatically enter into the DAB
mode and perform auto scan, after the scan has finished, the first alphanumerically found station
will be selected and you can now start to operate your music centre.
4. To select other modes, repeatedly press the /Mode button.
Clock Setting
During unit standby, press and hold the Info/Menu button until “Clock set” is displayed, then press the
►II button to enter “Clock set”, and you can now select “Auto sync” or “Manual set” - repeatedly press
the I◄◄ or ►►I button followed by pressing the ►II button again to confirm your selection.
When “Auto sync” is selected, the clock will be automatically updated by the broadcasted information, it
is not necessary to set the clock manually.
DAB Autotune & Manual Tune
Press and hold the Info/Menu button to enter into the “DAB menu” to select “Autotune” or “Manual
tune”. When “Autotune” is activated, it will scan for the entire DAB Band III channels and after the scan
has finished, the first alphanumerically found station will be automatically selected. To explore and select
listening to other found stations, press the I◄◄ or ►►I button followed by pressing the ►II button.
When “Manual tune” is selected, press the I◄◄ or ►►I button to move through the DAB channels
(5A – 13F), when your desired channel appears in the display, press the ►II button to confirm.
Storing and Recalling Stored Stations
In either DAB or FM mode, you can store up to 20 stations into the station presets; this will enable you to
get direct access to your favourite stations.
1. To store a preset, first tune to your desired station, then press and hold the Program button until
the display shows the preset number and flash.
2. Repeatedly press the I◄◄ or ►►I button to select your desired station preset number, then press
the Program button again to confirm.
3. Repeat the above procedure to store more stations into the station presets.
4. To recall a preset station, first press on the Program button once, then press the I◄◄ or ►►I
button to scroll up or down the presets that you have stored, when you see your desired preset
number in the display, press the ►II button. Or you can press the Preset + or Preset - button on the
remote control to recall the presets directly.