CAD-375 MODE BD/LD PTY TA MUTE AS/PS 1 PAU 9 1 MODE AF 10 2 RPT 3 INT 4 RDM 5 -10 18 6 +10 16 7 17 15 11 INSTRUCTION MANUAL BD/LD PTY TA MUTE AF AS/PS 1 PAU 2 RPT 3 INT 4 RDM 5 -10 6 +10 CAR STEREO CD/CDR/CDRW/MP3/WMA PLAYER WITH PLL FM STEREO RADIO 14 2 3 12 19 20 21 22 23 24 6 13 8 25 5 RDS DETACHABLE FRONT PANEL 4 (1-6)
1 PAU 2 RPT 3 INT 4 RDM 5 -10 6 +10 LOCATION OF PARTS AND CONTROLS 9 1 10 MODE 18 16 7 17 15 11 25 5 BD/LD PTY TA AS/PS MUTE 1 PAU 14 AF 2 3 12 19 2 RPT 3 INT 4 RDM 5 -10 6 +10 20 21 22 23 24 MODE BD/LD 6 13 8 PTY 4 (1-6) TA A AS/PS MUTE 1 PAU 2 RPT 3 INT 4 RDM 5 -10 6 +10 1. POWER ON/OFF ( ) 2. FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER/ TA SEEK/PI SOUND/RETUNE/MASK DPI/EON/BEEP/TA VOL/ADJ TIME/AUDIO DSP 3.
ISO CONNECTOR RCA Jack Line Out: Red (right) White (left) RCA Jack Line In: Red (right) White (left) CONNECTOR A 4. MEMORY +12V 5. AUTO ANTENNA OUTPUT 7. +12V (TO IGNITION KEY) 8. GROUND Note: (connector A no. 7) must be connected by car ignition key in order to avoid that car battery becomes weak when the car will be not used for long period. B 1 3 5 7 2 4 6 8 5 7 4 A 8 CONNECTOR B 1. REAR RIGHT SPEAKER (+) 2. REAR RIGHT SPEAKER (-) 3. FRONT RIGHT SPEAKER (+) 4. FRONT RIGHT SPEAKER (-) 5.
TO SUPPORT THE UNIT 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. UNIT RELEASE CASE DASH BOARD HEX NUT LOCK WASHER PLAIN WASHER CAR BODY REAR SUPPORT STRAP TAPPING SCREW M5 X 15 HEX BOLT 4 3 4 Dashboard 6 5 8 2 7 10 5 A 1 Detaching and attaching the front panel The front panel of this unit can be detached in order to prevent the unit from being stolen. 9 6 4 B Front panel DETACHING THE FRONT PANEL Before detaching the front panel, be sure to press the button to OFF first.
OPERATION 1. POWER ON/OFF ( ) By pressing this key, the unit is on or off. This unit is turned on by pressing any key. 2,3.FUNCTION SELECT BUTTON: BASS/TREBLE/BALANCE/FADER / TA SEEK/PI SOUND/RETUNE/MASK DPI/EON/BEEP/TA VOL/ADJ TIME/AUDIO DSP Turning the VOL knob Right or Left (3), you can adjust VOL/BASS/TREB/BAL/FAD. To select other functions, press the VOL knob shortly until the desired functions is shown on the display. Figure 1 shows how control functions are selected using the VOL knob.
USING THE RDS FUNCTION What is RDS? The RDS (Radio Data System) is a digital information system developed by the EBU (European Broadcast Union). Piggy-backed on normal FM broadcasts, RDS offers a variety of information services and automatic retuning functions for RDS-compatible car stereos. In 1988, RDS became available in the United Kingdom, France, West Germany, Ireland and Sweden. Test transmissions are being conducted in many other european countries.
13. ‘SCAN’ AUTOMATIC TUNING CONTROL (SCAN) This key is operated as RADIO SCAN The operation is similar as normal search but different thing is holding 5 seconds on every station detected in RADIO SCAN mode. 14. MUTE BUTTON (MUTE) Press this button, audio will disappear. Press this button again in order to hear audio newly. 15. PANEL RELEASE BUTTON ( ) Press this button and the right-hand part of the panel will be released. 16.
4 (1-6) 26. RESET Reset button is placed on the housing. The reset button is to be activated for the following reason: • Initial installation of the unit when all wiring is completed. • All the function button do not operate. • Error symbol on the display. 26 TECHNICAL SPECIFICATIONS CD/MP3/WMA PLAYER SECTION Signal to Noise Ratio Channel Separation Frequency Response RESET > 60dB > 50 dB (1kHz) 20Hz - 20 kHz TUNER (FM) Frequency range 87.5-108 MHz Sensitivity 2.