HIGH EFFICIENCY POWER AMPLIFIER OWNER'S MANUAL CAR AUDIO SYSTEM PLEASE READ CAREFULLY BEFORE INSTALLING OR OPERATING THIS UNIT CAP-4300 WARNING Make sure you choose a suitable place to mount the unit. The position should be completely dry with a good circulation of air, and from a mechanical point of view very stable.
System planning Proper system planning is the best way to maximize your amplifier performance. By planning your installation carefully you can avoid situations where the performance of the reliability of your system is compromised. Your authorized dealer has been trained to maximize your system's sonic potential. Your dealer is a valuable resource in helping you with your system design and installation.
Power Connection Leads Notes on the power supply Connect the + 12V power input lead only after all other leads have been connected. Be sure to connect the ground wire of the unit securely to a metal part of the car. A lose connection may cause a malfunction of the amplifier. REMOTE: The unit is turned on by applying + 12Volts to this terminal This terminal dose not draw heavy current like the two power terminal so a thinner connecting wire is acceptable.
system 1: 4 channel mode ENG-3
system 2: 3 channel mode ENG-4
system 3: 2channel bridged connection ENG-5
Troubleshooting symptom possible cause action to take no output low or no remote turn-on input check remote turn-on voltage output at amplifier and correct as needed fuse blown check power wire integrity and reversed polarity, repair as needed and replace fuse power wires not connected check power wire and ground connections and repair of replace as needed check input connections and audio input not connected or signal integrity, repair or replace no output from source as needed speaker wires not
symptom possible cause action to take manual distorted output (cont'd) speakers are blown check system with known working speakers and repair or replace as needed poor bass response speakers wired wrong check speaker polarity and repair polarity causing cancellation as needed at low frequencies battery fuse blowing amplifier fuse blowing crossover set incorrectly reset crossovers referring to the multi-cross crossover configuration section of this manual for detailed instructions impedance load
Specifications Amplifier section Power output 4Ω (watts) 50W X 4 CH 150W X 2 CH bridged channel pair THD ≤0.1% frequency response (± 1dB) 20Hz~20KHz signal to noise ratio >88dB sensitivity 0.
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S Electric and electronic equipment contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment) is not handled correctly. Electric and electronic equipment is marked with the crossed out trash can symbol, seen above.