User Manual

CAU-438 ENG
Quick Set-Up Guide
WIRING UP YOUR RADIO
***IMPORTANT*** Please make sure the yellow wire is connected to the permanent live feed
(+12V) of the vehicle battery for the preset memory's Disconnect negative battery terminal
from battery before starting installation. Consult the vehicle owner's manual for proper
instructions.
1. Install the Radio using the Din-Front
Mount or Din-Rear Mount Method.
2. The Radio is equipped with ISO
connector. ISO connector is the universal
connector for the connection of car
radio.
3. Make sure that you have a good chassis
ground. Good ground connections will
eliminate most electrical noise
problems.
4. Please seek professional advice if you are
inexperienced installing this type of
product.
WORKING WITH THE UNIT
1. USB Flashdrive & SD Card
Simply plug your USB Flashdrive or SD Card (or both) into the
USB socket/Card slot. The contents will be played
automatically. These can be removed at any time.
2. Aux-in Jack
The front Aux-in Jack can be used for connecting additional audio
devices (i.e.MP3 players/lpods) to the unit The Aux-in cable (supplied
with the unit) can be used for this connection. Simply connect one end
into the Aux-in Jack and the other to your MP3/lpod.
3. Radio
Press the BND / ID3 button to select RADIO mode. Press the PTY
button to select suitable band. You can press and hold the seek
up/down button to search for your favourite stations, or you can press
and hold the APS button to automatically scan tne strongest stations
and save them as presets.
YELLOW
Connect to
the B+12V
RED
Connect to lgni
tion Key
BLACK
Ground
Permanent
+12V Fused
Auto
Antenna
Ignition
Key
+12V
GND
Fused
Rear Left
Front Left
Front Right
Rear Right