Operation Manual

User Manual
Appearance and Functional Description
1. Menu key
2. Up key
3. Down key
4. Mode key
5. Screen
6. GPS port
7. HDMI port
8. Bracket base
9. Reset
10. USB port
11. Lens
12. Power key
13. TF card slot
14. OK key
15. Infrared light
16. Speaker
17. MIC
Power capacity
Full Middle Low
1. Directly connect the car charger to the USB port of the DVR, then the device will automatically turn on and charge the
battery. In charging, the charge indicator will be on; after charge is over, it will be off.
2. To charge the device with USB, be sure to connect one end of the USB data cable to PC and the other end to the DVR. In
charging, the charge indicator will be on; after charge is over, it will be off.
Installation and Removal of TF Card
1. In the direction as indicated, insert the TF card into the slot until it is held firmly.
2. To take the TF card out, slightly press the TF card to eject it out.
Note:
1. Observe the direction to insert the TF card; if the direction is reverse, the device and the TF card may be damaged.
2. When the TF card is inserted into the device, the machine will set the TF card as preset storage unit and the data in the
original TF card will be unreadable.
3. If the TF card is incompatible with the device, please insert the card again or replace it for retry.
4. Max. 32G supported.
5. Always use a high-speed TF card (CLASS4 above).
Use Guidelines
DVR On/Off
1. Press the On/Off key around 1s to switch on the device and 3s to switch it off.
2. Insert the device into the car charger to automatically switch on and turn off the card charger to automatically switch it off.