USER MANUAL CR-420 WWW.DENVER-ELECTRONICS.COM Please read this user manual carefully before start using the product.
CONTROLS AND INDICATORS 1. 2. 3. 4. “ON/OFF ” button “HOUR TU -“ button “MIN TU +” button “DIMMER HI/LOW SLEEP/SNOOZE” button 5. “AL1 VOL -“ button 6. “AL2 VOL +” button 7. “SET/PRE M+” button 8. 9. 10. 11. 12. 13. 14. Battery compartment below Antenna Power cord “AL1 BUZZER” signal “AL1 RADIO” signal “AL2 BUZZER” signal “AL2 RADIO” signal PREPARATION FOR USE This clock radio includes a battery backup system that will maintain the time and alarm settings during a temporary power interruption.
1. Press “HOUR TU -” button (2) repeatedly to change the ‘hour’ setting. 2. Press “MIN TU +” button (3) repeatedly to change the ‘minute’ setting. 3. Press “SET/PRE M+” button (7) to confirm at the time and the display will stop flashing. Note: The time and alarm times can only be set when the radio is turned off. SETTING THE ALARM TIME This clock radio has dual alarms that can be set and used independently. The procedure to set both alarms is the same.
5. Press “AL1 VOL -“ button (5) or “AL2 VOL +” button (6) to adjust volume level. The display changes to show the volume level indication (00 to 15). 00 is the quietest and 15 is the loudest. 6. Extend and reposition the antenna (9) for better radio reception. Pre-set Station Memory 1. The radio can store up to 10 stations. 2. To store a station in memory, tune to the desired radio station.
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S Electric and electronic equipment contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment) is not handled correctly. Electric and electronic equipment is marked with the crossed out trash can symbol, seen below.