Operation Manual

ManualsBrandsDenver ManualsAudioCRP-717

ENGLISH

LOCATION OF CONTROLS

FUNCTION AND CONTROLS

1. ANGLE / SHARPNESS CONTROLLER

2. PROJECTION TIME 180° FLIP

3. CLK.ADJ./ MEMORY / M+

4. << TUNE DOWN / HOUR

5. >> TUNE UP / MIN

6. SNOOZE / SLEEP / DIMMER

7. PROJECTI ON ON/OFF

8. VOLUME DOWN / ALARM 1 ON-OFF SET

9. VOLUME UP / ALARM 2 ON-OFF SET

10. POWER ON – OFF / ALARM OFF

11. ALARM 1 BUZZER INDICATION

12. ALARM 1 RADIO INDICATION

13. ALARM 2 BUZZER INDICATION

14. ALARM 2 RADIO INDICATION

15. RATING LABEL (BOTTOM OF UNIT)

16. LED DISPLAY

17. AC POWER CORD

18. BATTERY COMPARTMENT COVER

19. FM ANTENNA

20. SPEAKER

ENG-1

DENVER CRP-717

Summary of content (9 pages)

PAGE 1
DENVER CRP-717 ENGLISH LOCATION OF CONTROLS FUNCTION AND CONTROLS 1. ANGLE / SHARPNESS CONTROLLER 2. PROJECTION TIME 180° FLIP 3. CLK.ADJ./ MEMORY / M+ 4. << TUNE DOWN / HOUR 5. >> TUNE UP / MIN 6. SNOOZE / SLEEP / DIMMER 7. PROJECTI ON ON/OFF 8. VOLUME DOWN / ALARM 1 ON-OFF SET 9. VOLUME UP / ALARM 2 ON-OFF SET 10. POWER ON – OFF / ALARM OFF 11. ALARM 1 BUZZER INDICATION 12. ALARM 1 RADIO INDICATION 13. ALARM 2 BUZZER INDICATION 14. ALARM 2 RADIO INDICATION 15. RATING LABEL (BOTTOM OF UNIT) 16.
PAGE 2
POWER CONNECTION 1. This product operates on AC230V~ 50Hz power supply. Plug the AC power cord into a household outlet AC source. 2. Clock display will flash 0:00 until set to correct time. INSTALLING/REPLACING THE BACK-UP BATTERY This unit is equipped with a battery back-up system, requiring one DC3V CR2032 lithium battery (not included) to maintain the time settings and radio presets during AC power outage. 1. Unscrew and remove the BATTERY COMPARTMENT COVER. 2.
PAGE 3
WARNING DO NOT INGEST BATTERY, CHEMICAL BURN HAZARD This product contains a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death. Keep new and used batteries away from children. If the battery compartment does not close securely, stop using the product and keep it away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
PAGE 4
SETTING ALARM 1 1. Please ensure the radio is OFF. 2. Press and hold the VOLUME DOWN / ALARM 1 ON-OFF SET button to set ALARM. The alarm time will flash on the display. 3. Press the << TUNE DOWN / HOUR button to increase the HOUR. 4. Press the >> TUNE UP / MIN button to increase the MINUTES. 5. To toggle between Buzzer and Radio alarm mode, press the VOLUME DOWN / ALARM 1 ON-OFF SET button until the desired option is highlighted on the LED display.
PAGE 5
SNOOZE FUNCTION 1. When the alarm (buzzer or radio) is triggered, press the SNOOZE/SLEEP/DIMMER button. The alarm will turn off for approximately 9 minutes. 2. To cancel the SNOOZE function, press the POWER ON – OFF / ALARM OFF button. LISTENING TO THE RADIO HINTS FOR BEST RECEPTION FM - To insure maximum FM tuner reception, unwrap and fully extend the EXTERNAL FM WIRE ANTENNA for best FM radio reception. 1. Press the POWER ON – OFF / ALARM OFF button once to turn radio ON. 2.
PAGE 6
SLEEP TIMER OPERATION The sleep timer allows you to play music for a preset amount of time ranging from 90 minutes to 10 minutes. It is commonly used by people who prefer to go to sleep to music. 1. In radio mode, Press the SNOOZE/SLEEP/DIMMER button. The display will show 90 minutes, your clock radio will turn off in 90 minutes. 2. To change the number of minutes for the SLEEP timer, press the SNOOZE/SLEEP/DIMMER button until you see the desired number of minutes.
PAGE 7
RESETTING THE UNIT If the system does not respond or exhibits erratic or intermittent operation, you may have experienced an electrostatic discharge (ESD) or a power surge that triggered the internal microcontroller to shut down automatically. If this occurs, disconnect the AC POWER CORD from the wall and remove the backup battery from the compartment. Wait at least 3 minutes, and reinsert the battery for the back-up, and reattach the AC Cord to the wall.
PAGE 8
WARNING 1. No naked flame sources, such as lighted candles, should be placed on the apparatus. 2. Do not place the product in closed bookcases or racks without proper ventilation. 3. The mains plug is used as the disconnect device, the disconnect device shall remain readily operable. 4. The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc. 5.
PAGE 9
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S www.denver-electrionics.com Electric and electronic equipment contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment) is not handled correctly. Electric and electronic equipment is marked with the crossed out trash can symbol, seen below.