Operation Manual

RESETTING THE UNIT
If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge
(ESD) or a power surge that triggered the internal microcontroller to
shut down automatically. If this occurs, disconnect the AC POWER
CORD from the wall and remove the backup battery from the
compartment. Wait at least 3 minutes, and reinsert the battery for
the back-up, and reattach the AC Cord to the wall. The unit is now
reset, so you will need to setup the unit time and alarms again.
SPECIFICATIONS
Frequency : FM 87.5 – 108 MHz
Battery backup : 1 x 3V CR2032 at lithium battery (not included)
Power source : AC 230V ~ 50Hz, 5W
Projection distance: ≤ approx. 90 to 270cm
ENG-7