Original Instruction DENVER HBO-6610 www.denver-electronics.com Before operating this vehicle, read all the instructions for safe assembly and operations. User’s manual can guide you through the functions and usage of the hoverboard. Before using this hoverboard, familiarize yourself with how to operate, so that you can keep the hoverboard in the best condition possible.
Chapter 1 General information We urge owners of this hoverboard model to charge and store the hoverboards in a safe place. To increase the safety and life of the batteries associated with this model it is important not to charge this model if the temperature is below 5℃ or above 45℃. In addition, the charger must be disconnected when the battery is fully charged. Only use the charger that is packaged with the hoverboard model. 1.1. - - - - - - 1.1.
1.3 The weight limitation of the operator The reason of the weight limitation: 1. guarantee the safety of the operator; 2. decrease the damage of overloading. Maximum load: 100kg. Chapter 2 Operating the Balance scooter 2.1. Description and identification 2.2. Calibration If your hoverboard seems to pull to the left or right, you may need to recalibrate its sensors.
2.4. Learn how to use it Step 1: Press the power button to turn on the hoverboard. Step 2: Put the hoverboard on a flat ground and make sure all safety measures are taken. Put one foot on the pad that will trigger the pedal switch to turn on the operation indicator, after the system enters the selfbalancing mode, put the other foot on the pad. Step 3: Take control of the hoverboards’ forwards or backwards, do remember the movement of your body should not be abrupt.
- During operation, the platform turns upside down will prohibit operation. Over speeding. The battery is not charged enough. Tire stall, two seconds later the scooter enters power off mode. The battery voltage is lower than the protection value, 15 seconds later the hoverboard enters into power off mode.
3.2. Battery & Operation Indicators The indicator is located in the middle of the hoverboard. It is used for operation information. - Battery indicator on the hoverboard will show green color as long as there is sufficient power on the battery to drive. - Battery indicator on the hoverbard will show red color when battery power is down(15-20% left) and you will you need to stop driving and start to recharge the hoverboard.
- Before starting, familiarize yourself with how to operate, so that you can keep the hoverboard in the best condition. When you are driving the hoverboard, make sure that all safety measures are taken. You should be wearing a helmet, knee pads, elbow pads and other protective gear. The driver should not wear loose or hanging clothing, shoelaces, etc. that can get caught in the wheels of the hoverboard. Hoverboard is only for personal entertainment. You are not allowed to ride it on public streets.
Do not use the battery in the following cases. Giving out some odor or excessive heat. Leakage of any substance. It is prohibited to disassemble the battery. Do not touch any substance leaking out of the battery. Do not let children and animals touch the battery. Batteries contain dangerous substances inside. It is forbidden to open the battery and to stick objects into the battery. Use only the supplied charger. Don’t over charge lithium batteries. The battery pack consists of lithium batteries.
- If charging at lower or higher temperatures, there is a risk that the performance of the battery will be reduced and a potential risk of damage to the product and personal injury. - Charge and store the product in an open, dry area and away from flammable materials (i.e. materials that may burst into flames). - Do not charge in sunlight or near open fire. - Do not charge the product immediately after use. Let the product cool down for one hour before charging.
Chapter 7 The maintenance of the hoverboard The hoverboard needs to be maintained. This chapter mainly describes the relevant steps and important operation reminders to maintain it. Please make sure that the power and charge coil are off before you do the following operation. You should not operate when the battery is charging. 7.1. Cleaning Make sure the power and the charge coil are off. Wipe the shell of hoverboard with soft cloth.
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S Electric and electronic equipment and included batteries contains materials, components and substances that can be hazardous to your health and the environment, if the waste material (discarded electric and electronic equipment and batteries) is not handled correctly. Electric and electronic equipment and batteries is marked with the crossed out trash can symbol, seen below.
ENG 11
EC Declaration of Conformity (Machine Directive) The undersigned DENVER ELECTRONICS A/S Omega 5A, Soeften, 8382 Hinnerup, Denmark Company Name: Address: Certifies that the design and manufacturing of this product DENVER Product Model No.