Operation Manual

Eng-4
Section 2: Stand Installation
Monitor
StandBase
Foam
Stand Stem
Button
StandPlate
NO.1Screw
14mmx1
Stand Stem
NO.1 Screws
12mmx2
Monitor
Stem
StandPlate
Button
Keep the foam over the monitor before attaching the stand. Follow the
steps below to finish the installation.
1. Open the package, take out the product with foam still attached, and gently
place it on a desktop or table.
2. Take out the two parts of the stand, remove the foam covering the back of the
monitor, andpressthebuttontoremovethestandplate.
3. Use the screwdriver and two 12mm NO.1 screws to fasten the stand plate to
thestem.Next,usetheremaining14mmstandscrewstofastenthebase
tothestem.
4. Insert the stand’s plate into the opening on the back of the monitor. It should
click into place. Make sure the stand is securely attached to the back of the
monitor then remove the monitor from the remaining foam section and stand
it up on a table or desk as desired.
If needed, the stand can easily be detached from the monitor by pressing the
button near the stand plate. Make sure the monitor is laid on a flat surface
before removing the stem.