User manual

ManualsBrandsDenver ManualsBaby CareSC-15

WIRELESS 2.4GHz HANDHELD BABY MONITOR

DENVER SC-15 USER MANUAL

Please read all instructions thoroughly before using your Baby Monitor.

Content and Features

Features CAMERA:

1. Antenna 2. ON/OFF Switch

3. Tilt Adjustment Knob. (Controls up and down tilt of camera for optimal viewing)

4. Night Vision LED's: Provides a black and white view of baby even in a darkened room.

5. Microphone. 6. Channel Switch 1,2,3,4 7. Power Indicator

8. Camera Lens 9. AC Adaptor 10. AC Adaptor Jack

HANDHELD MONITOR:

1. Power Indicator 2. Colour Display 3. LCD Digital Alarm Clock

4. Function Button 5. Speaker 6. UP/DOWN Button

7. Volume Control 8. ON/OFF Switch 9. Earphone Jack

10. Antenna 11. Belt Clip/Monitor Stand 12. Battery Compartment

13. Video Out Jack 14. AC Adaptor Jack

AC Adaptor:

The AC Adaptors are low voltage power sources that

allow you to use your household electricity to run the

Baby Monitor. Connect the AC Adaptors to the AC

Adaptor Jack in the Parents and Baby Units. Both

plug into any standard volt electrical outlet in your

home. It is recommended to turn off the units before

plug in or unplug the adaptors.

Summary of content (10 pages)

PAGE 1
WIRELESS 2.4GHz HANDHELD BABY MONITOR DENVER SC-15 USER MANUAL Please read all instructions thoroughly before using your Baby Monitor. Content and Features Features CAMERA: 1. Antenna 2. ON/OFF Switch 3. Tilt Adjustment Knob. (Controls up and down tilt of camera for optimal viewing) 4. Night Vision LED's: Provides a black and white view of baby even in a darkened room. 5. Microphone. 6. Channel Switch 1,2,3,4 7. Power Indicator 8. Camera Lens 9. AC Adaptor 10. AC Adaptor Jack HANDHELD MONITOR: 1.
PAGE 2
Care and Maintenance 1. The Baby Monitor is for indoor use only. Do not place the Baby Unit under direct sunlight. Outdoor use may damage the Baby & Parents Units. 2. Clean the outer surface of Baby & Parent Units with a cloth dampened with water or mild cleaning solution LIGHTLY. Do not immerse any part of the product in water. 3. Do not drop the product or physically damage it, otherwise electronic components may be affected by such abuse. Caution: 1.
PAGE 3
. Place the Parents Unit in different locations you intend to use inside the house. As with any audio equipment, feedback or a high pitched sound may occur if the Parents & Baby Units are too close to each other. 4. Set both units into the same channel. To test video reception quality 5. Check the video reception on the Parents Unit screen. Make sure you check the reception in all areas you intend to use both units. 6. To adjust Brightness, Contrast, or Color, please refer to the Operation Section. 7.
PAGE 4
- To prevent entanglement and overheating, only mount the Baby Unit at where the AC adaptor cord can reach a standard wall outlet. Unwrap and fully extend the AC adaptor cord. NEVER use an extension cord. - For best viewing, position the Baby Unit approximately 3' (1m) away from the child. - Mount the Baby Unit in a location where the camera lens is unobstructed. Use the tilt and swivel adjustments to properly aim the camera. - Allow adequate ventilation of the Baby Unit when mounted on a wall.
PAGE 5
2. Install the supplied rechargeable batteries into the battery compartment (Figure B). Close the battery compartment door and realign the belt clip. 3. For the initial use, we recommend the charging time is 10 hours, After that, the recommended charging time is 10 hours. Use only the supplied 6V AC adaptor for charging the supplied rechargeable batteries. Plug into any nearby standard electrical outlet at home. When the batteries are charging, the power indicator lights up with flashing red colour.
PAGE 6
Baby Unit 1. Connect the Baby Unit with the supplied 9V AC adaptor. standard electrical outlet at home. Plug it into the nearest 2. Turn on the unit by switching the ON/OFF switch to ON position. indicator lights up in green. 3. Switch to set both units to the same channel until you receive the correct picture and clear voice on the Parents Unit. 4. Adjust the focus by turning the camera lens clockwise or anti-clockwise until you see a clear picture on the monitor.
PAGE 7
3. Press or to adjust the picture's brightness from 1 to 8 levels. Level 8 is the brightest. or leave the unit alone for 5 seconds 4. To confirm the setting, press to return to its normal operation. III) Contrast Setting / until you see "? 1. Press 2. Press to enter the contrast adjustment mode or to adjust the picture's contrast from 1 to 8 levels. 3. Press Level 8 is the highest level. 4. o confirm the setting, press or leave the unit alone for 5 seconds to return to its normal operation. B.
PAGE 8
6. Press 7. Press to select the desired number for that digit. to confirm the setting. The symbol" " will appear III) Stop Clock Alarm 1. Press D. / or to stop the clock alarm Connect Parents Unit with TV Set By connecting the Parents Unit with TV set, the video will be displayed on the TV set. 1. Connect the Parents Unit with the TV set with the supplied TV cable. (For PAL System) 2. Turn on the TV, set it to the video viewing channel; user could see the image captured by Baby Unit on TV screen now.
PAGE 9
Picture flickers in low light Picture flickers in low light Audio feedback (squealin g) Dark picture at night Object is too close to the Baby Unit Baby or Parents Units are near metal concentration Signal interference due to other monitors, cordless or cellular telephones, etc. Parents Unit is too close to the Baby Unit Volume is set too high Power is turned off Batteries may be dead -Remove objects that are too close to the Baby Unit or move the Baby Unit further apart.
PAGE 10
II. Baby Unit 1. 2. 3. 4. 5. 6. Operation voltage: AC/DC 9.0V 300mA Temperature range: 0°C -50°C Power consumption: 2.7W Operation frequency: 2.4GHz-2.4835GHz Sub-carrier frequency: 6.5MHz Mic sensitivity: 1 to 2 meter Instructions on environment protection Do not dispose of this product in the usual household garbage at the end of its lifecycle; hand it over at a collection point for the recycling of electrical and electronic appliances.