Operation Manual

GB-1

INSTRUCTION MANAUL TC-26

LOCATION OF CONTROL

1. ANTENNA

2. CD DOOR

3. TUNNING CONTROL

4. DIAL POINTER

5. OPEN / CLOSE

6. LED DISPLAY

7. REPEAT

8. FUNCTION SELECTOR

9. RANDOM

10. VOLUME +

11. PROGRAM

12. VOLUME –

13. SKIP –

14. STOP

15. PLAY / PAUSE

16. SKIP +

17. STANDBY

CD OPERATION

PROGRAM

Up to 20 tracks can be programmed for disc play in any order.

Be sure to press the “STOP” button before use.

1. Press the “PROGRAM” button, the display will show “01” and flash.

2. Select desired track by using the “SKIP +” or “SKIP -” button.

3. Press the “PROGRAM” button again to confirm desired track into the

program memory.

4. Repeat step 2 and 3 to enter additional tracks into the program

memory.

5. When all the desired tracks have been programmed. Press the

“PLAY/PAUSE” button to play the disc in the order you have

programmed.

6. Press the “STOP” button twice to terminate programmed play and

the program indicator will turn off.

PAGE 1
GB INSTRUCTION MANAUL TC-26 LOCATION OF CONTROL 1. ANTENNA CD OPERATION 2. CD DOOR PROGRAM 3. TUNNING CONTROL Up to 20 tracks can be programmed for disc play in any order. 4. DIAL POINTER Be sure to press the “STOP” button before use. 5. OPEN / CLOSE 1. Press the “PROGRAM” button, the display will show “01” and flash. 6. LED DISPLAY 2. Select desired track by using the “SKIP +” or “SKIP -” button. 7. REPEAT 3. Press the “PROGRAM” button again to confirm desired track into the 8.
PAGE 2
REPEAT Electric and electronic equipment contains materials, components Press the “REPEAT” button before or and substances that can be hazardous to your health and the during playing CD, a single track or environment, if the waste material (discarded electric and electronic all the tracks can be repeated. equipment) is not handled correctly. Each press switches the repeat mode as Electric and electronic equipment is marked with the crossed out follows: trash can symbol, seen below.