Manualshelf

User Manual

ManualsBrandsDenver ManualsAudioBoombox with toploading CD player & PLL FM radio AUX input for connection of MP3 player and more
1234
3
Tuning to an FM station
1. In FM mode, press the FM SCAN button to initialize scan. When an available radio station is tuned to, the scan stops.
2. Press the Next/TUN+ or Previous/TUN- button to fine tune each frequency in 0.1MHz steps, if necessary.
Storing an FM station
Your boom box can store up to 10 FM radio stations in its preset memories for instant access to your favorite stations.
1. Tune the boom box to the FM radio station that you wish to preset.
2. Press and hold the PRESET button for approximately 2 seconds until ‘P01’ is displayed.
3. Press the PRESET button to select a preset number (1-10) you would like to store the radio station to.
4. Press and hold the PRESET button. ‘P XX stored’ is displayed, where ‘X’ is the number of the preset (1-10).
Note: If there is already an existing FM station stored under a preset, the newly stored station overwrites the old one.
Selecting a preset FM station
1. In FM mode, press the PRESET button to select a preset station number (1-10) you would like to listen to.
2. Press and hold the PRESET button to confirm selection. The preset station begins to broadcast.
Note: If no FM station has been stored under a preset number, ‘Preset Empty’ is displayed, and then the boom box
reverts to the previously selected radio station after a few seconds.
CD Mode
Check that your Boom box is in CD mode. To enter CD mode, press repeatedly the /SOURCE button until CD mode is
displayed. The display shows flashing ‘_ _ _’, followed by ‘NO’ if no CD is loaded.
AUX mode
Check that your boom box is in AUX mode. To enter AUX mode, press repeatedly the /SOURCE button until AUX mode
is displayed. Through AUX connection, you can listen to an external audio device through the speakers of the boom box.
1. Using a 3.5mm audio cable (not included), connect the AUX IN jack on the boom box to the headphone jack (or
auxiliary output) on an external audio device.
2. Start play on the connected audio device.
3. To adjust volume, you may use the volume controls on the boom box.
Other information
Technical specifications
AC input power
230V AC, 50Hz
Battery power (optional)
6 x 1.5V C size (LR14) (not included)
Speaker output
2 x 1W RMS
FM frequency range
87.5 MHz to 108 MHz