Instruction manual

REPEAT

Press the “REPEAT” button before or during playing CD, a single track or all the tracks can be repeated.

Each press switches the repeat mode as follows:

1 - REPEAT 1 ( The repeat indicator is flashing. )

2 - REPEAT ALL ( The repeat indicator is steadily on. )

3 - NORMAL PLAYBACK

REPEAT 1 REPEAT ALL

NORMAL

PLAYBACK

CD OPERATION

E-8

PROGRAM

Up to 20 tracks can be programmed for disc play in any order.

Be sure to press the “STOP” button before use.

1. Press the “PROGRAM” button, the display will show “01” and flash.

2. Select desired track by using the “SKIP +” or “SKIP -” button.

3. Press the “PROGRAM” button again to confirm desired track into the program memory.

4. Repeat step 2 and 3 to enter additional tracks into the program memory.

5. When all the desired tracks have been programmed. Press the “PLAY / PAUSE” button to play the

disc in the order you have programmed and the program indicator flashes.

6. Press the “STOP” button twice to terminate programmed play and the program indicator will turn off.

Instructions on environment protection

WWW.DENVER-ELECTRONICS.COM

Electric and electronic equipment contains materials, components and substances

that can be hazardous to your health and the environment, if the waste material

(discarded electric and electronic equipment) is not handled correctly.

Electric and electronic equipment is marked with the crossed out trash can symbol,

seen below. This symbol signifies that electric and electronic equipment should not be

disposed of with other household waste, but should be disposed of separately.

All cities have established collection points, where electric and electronic equipment

can either be submitted free of charge at recycling stations and other collection sites,

or be collected from the households. Additional information is available at the

technical department of your city.