User manual

ENG-1
DENVER WCT-3004
Wildkamera
Quick Start Guide
Overview
1) Bottom Cover
2) SD-Card Slot
3) USB Connector
4) TV Out connector
5) PIR
6) Infrared Flash
7) Lens
8) 2 inch color LCD Display
9) Sound recorder
10) Lock
11) Power switch
12) Battery Depot
13) Portable remote controller
14) DC 6V Input
The camera has 3 basic operation modes:
1. OFF mode: Power switch is at OFF position.
2. ON mode: Power switch is at ON position.
3. TEST mode: Power switch is at TEST position.
In the above three modes, the OFF mode is the specified safe mode when replacing the SD-card or batteries and transporting the camera.
A. There are 3 modes under system setting for your selection.
a. Camera
It only takes photos at a time.
b. it only takes videos at a time.
c. Camera &Video.
It takes photo firstly, then takes videos at time.
B. There are also 2 ways to take photos or videos.
a. Manually by using the remote control
After sliding power switch to ‘TEST’, without any menu on the screen, press SHUTTER(OK) on the remote control to take
photos or videos.
b. Automatically
After sliding power switch to ON, the LED blinks 15 seconds, then the camera takes photos or videos when the movement is detected.
C. To view the photos of videos on the camera, please turn off the camera, slide power switch to Test, press right arrow key on remote
control to enter view model.
a. Photos
Press up or down on the remote control to view the previous of next photo.
b. Videos
Press left button on the remote control to start the video, pres left button again to stop.
Note: Press OK to return to screen.