Operation Manual

6V DC IN
AUX IN
3 1
6 7
4
2
5
8
9
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
WR-40
FM RADIO
ENGLISH
AC Adaptor(Included)
230 VOLT AC ADAPTER IS ONLY FOR USE IN-DOOR! NOT FOR USE OUTDOOR!
The AC adaptor(included) for use with the Utility Radio provides 6V DC output at 1 ampere
center pin positive.
Remove the rubber sheet which covers both the DC socket and AUX-in jack, insert the adaptor
plug into the DC socket of the radio. Whenever the adaptor is used, the batteries are automatically
disconnected.
The AC adaptor should be disconnected from the mains supply and the radio when not in use.
Aux-In Function
1. To use it, plug in Aux Cable (3.5mm connector) available at your local dealer and adjust the
volume control to a comfortable listening level.
2. You can start playing audio files from your AUX compatible device. For instructions on how to
play audio files from your AUX compatible device, please refer to its own manual.
CAUTION :
TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG
TO WIDE SLOT, FULLY INSERT.
WARNING :
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT
EXPOSE THE APPLIANCE TO RAIN
OR MOISTURE.
The Lightning flash with
arrowhead symbol, with an
equilateral triangle is
intended to alert the user of
the presence of uninsulated
dangerous voltage within the
product's enclosure that may
be of sufficient magnitude to
constitute a risk of electric
shock to persons.
CAUTION: TO REDUCE
THE RISK OF ELECTRIC
SHO C K, DO NOT
REMOVE COVER (OR
BACK). NO USER
SERVICEABLE PARTS
INS IDE. REF ER
SERVICING TO
QUALIFIED SERVICE
PERSONNEL.
The exclamation point within
an equilateral triangle is
intended to alert the user of
the presence of important
operating and maintenance
(servicing) instructions in the
literature accompanying the
appliance.
1. Power / Volume control Knob
2. FM Antenna
3. Tuning Knob
4. LCD display
5. Speaker
6. Aux in Jack
7. AC adaptor jack
8. Battery Compartment
9. Carrying Handle
Electric and electronic equipment contains materials, components and substances that can be
hazardous to your health and the environment, if the waste material (discarded electric and electronic
equipment) is not handled correctly.
Electric and electronic equipment is marked with the crossed out trash can symbol, seen above.
This symbol signifies that electric and electronic equipment should not be disposed of with other
household waste, but should be disposed of separately.
All cities have established collection points, where electric and electronic equipment can either be
submitted free of charge at recycling stations and other collection sites, or be collected from the
households. Additional information is available at the technical department of your city.
Installing Batteries
1. Unscrew the compartment fixture with a tool, lift up the battery compartment cover located
on the rear of your Utility Radio
2. Insert four “C” size (UM-2) batteries into the compartment. Ensure that battery is inserted in
accordance with the diagram shown.
3. Close the battery cover and screw the compartment fixture.
4. If the radio is not to be used for any extended period of time, it is recommended that the
battery is removed from the radio.
Operating your radio FM
1. Turn on your radio by switching the Power knob to FM position.
2. Rotate the tuning control to select the desired station. One short turn goes 0.1 mhz up/down.
Turn and hold for 1 seconds to make a scan after nearest station.
3. Adjust the Volume Control for comfortable listening.
4. To switch off the radio, turn the Power knob to Standby position.
5. The soft spring antenna is used for FM band reception.
Denver WR-40_Eng (A4)_R3 • 27 Aug 2014 • AT
Importer:
DENVER ELECTRONICS A/S
Stavneagervej 22
DK-8250 Egaa
Denmark
www.facebook.com/denverelectronics
ALL RIGHTS RESERVED, COPYRIGHT DENVER ELECTRONICS A/S