Installation guide

11
>./)711&.'*3456*!71&8%7)&".*A " D)=7%-* *
*
DEQX Calibration is installed with a standard Windows installation package. Insert the DEQX
Calibration CD-ROM in your CD-ROM drive. If you have auto run enabled the software installs
automatically. Alternatively you can run the file: setup.exe to start the installation. You will be
prompted to supply the user details and installation directory.
Launching DEQX Calibration Software:
To launch, double click the DEQX Calibration icon on
your desktop (if installed) or open the Windows Start Menu and choose DEQX Calibration
from the DEQX Calibration menu.
Connecting the DEQX unit to your PC or Mac with Windows:
The DEQX unit is supplied with a 5-metre long USB cable to allow a notebook computer running
DEQX-Cal™ to be adjusted from the listening position/s for comparing and saving to up to four
listening preference ‘profiles’ that can be selected using the remote control.
To connect the DEQX unit to a PC or Mac for the first time:
1. Connect the DEQX unit to the PC using the USB cable.
2. Turn on the power switch on the rear panel.
3. Windows should automatically detect the DEQX unit and advise new USB hardware found. If
the unit is not detected try turning the DEQX unit’s mains power off and on again. The PC should
recognize the new device.
4. Windows should start up a ‘Found New Hardware’ or similar Wizard. This wizard may ask if
Windows can connect to Windows Update to search for software. If so, choose 'No, not this time'
then click Next. At the next dialog choose the option to install the software automatically. The
Wizard should be able to find the driver by itself (you don't need to use the option of manually
finding the driver). Windows may pop up a window to say that the software hasn't passed
Windows logo testing. If this happens click on the Continue anyway button.
5. The Wizard will install the driver then ask you to click on Finish to close the Wizard.
6. Windows may pop up a brief message that new hardware has been installed.
7. Launch DEQX Cal™.
When the DEQX unit link to DEQX-Cal™ is successfully established, the link appears as
follows: If the link is not established, the link icon appears with a negated symbol:
Note using RS232: If USB is not available from your PC you can use the DEQX unit’s RS232
connector instead. To change the connection type in the software from USB to RS232, choose
Tools-Options. In the Configuration Options dialog choose the Configuration tab and select
RS232.
Choose Tools-Options. In the Configuration Options dialog choose the Configuration tab. Select
the appropriate port name in the Port Name field. If you are not sure which COM port is
appropriate, try each of them in turn