Installation guide

114
V&*M2#*=&)(*E"."*A:8*
L3!–!Left!Tweeter!
R3!–!Right!Tweeter!
L2!–!Left!Woofer!
R2!–!Right!Woofer!
L1!–!Mono!Subwoofer!
R1!–!Same!as!L1!
S%&*M2#*
L3!–!Left!Tweeter!
R3!–!Right!Tweeter!
L2!–!Left!Mid!range!
R2!–!Left!Mid!range!
L1!–!Left!Woofer!
R1!–!Right!Woofer!
I3!*!".D&':%7)&".*I7%72-)-%/*
Each speaker in a configuration can be adjusted using a number of parameters, as set out below.
These parameters are set in the Filter Properties box. To open this box, double-click on the box
of the appropriate speaker in the configuration window.
The configuration parameter options for a tri-amp speaker channel are shown in the following
diagram.
E7&.*9&1)-%*
Under this tab there are four options:
1. Use a correction filter for this loudspeaker - this is for adding a correction filter created
with the Calibration Wizard. See Configuring the PDC in the step by step section. Limit
filters can also be used with this option.
2. Use a crossover filter for this loudspeaker only - this is for using internal crossovers ie
crossovers between woofers and tweeters in a bi-amp configuration, or between woofers