Installation guide

12
Selecting a serial port
Verifying Your System Setup
Immediately after connecting up your sound system, you should perform a preliminary
configuration to verify your sound system wiring.
DEQX units capable of 3-way active (PDC-2.6/P, HDP3, HDP4, Express and Express-II):
The DEQX-Cal™ software automatically detects if your DEQX unit is capable of ‘active’ 3-way set
up, or is limited to ‘single amplifier - for full range, usually passive, speakers - with optional
subwoofer/s’ (e.g. DEQX ‘MATE’) .
In the case of ‘3-way active’ capable DEQX units Profiles 2 and 3 are configured with crossovers,
so if your system is a bi-amp setup (with or without sub-woofers), by selecting Profile 2 or 3 you
can listen to your speakers to ensure that they are correctly connected. Otherwise load one of the
DEQX configurations pre-installed in the default project (Project1), by following the steps below.