Installation guide

126
The following items all do as their names suggest, when the tick box next to them is ticked:
• Disable Front Panel Controls
• Reload last project at startup
• Save project file after each measurement
• Automatically highlight new items in project
• Show hint texts in charts The Reset ‘Do No Show Again’ Warnings button does as the
name suggests when clicked. Chart Tab The Chart tab is shown below. The Chart tab
allows you to modify the appearance of one or all of the types of charts that are used by
DEQX Cal. Chart Name - this allows you to specify which type of chart you wish to
modify. If the All Same tick box is ticked, all the charts will be modified. If it is not ticked,
you can modify one of the following
• Standard View - this applies to all charts except those listed below
• Correction View - the chart on the Correction tab(s) in the Calibration template
• Limit Design View - the chart on the Limits tab in the Calibration template
• Crossover Design View - the chart on the Crossovers tab in the Calibration
template You can choose whether the following elements of the charts will be
shown by default (this can be modified when in the chart): • Title