Installation guide

14
The default crossovers should be suitable for verifying your system setup. Of course the
crossover frequencies and slopes can be adjusted to best suit the characteristics of your speaker
drivers. Refer to DEQX Configuration Parameters in the reference section for details on how to
adjust the crossovers.
Click on the Save All to DEQX button to load the configuration into the
DEQX, in Profile 1.
Now you can listen to your speakers to ensure that they are correctly connected. The next step is
to install a microphone calibration, then perform measurement and calibration on the groups of
speakers in your system.
>./)711&.'*7*E&,%" # ( " . - *! 71&8 % 7) &" .*D&1-*
To install a microphone calibration, choose File-Install Microphone. Behringer microphones are
available with a generic calibration file while ‘Earthworks DEQX-Calibrated’ microphones are
supplied with customised calibration files.
In the Open dialog, browse for the microphone file name that corresponds to the serial number
engraved on your microphone (Alternatively, in the File name text box, enter the microphone file
name). Emailing DEQX with the serial number provides a microphone file, with a .mic extension.
If the microphone calibration file cannot be found, it may be downloaded from
http://www.deqx.com/upgrades.php or contact [e-mail]
!