Installation guide

23
The screen picture shows a completed Measurement Wizard dialog for the Run phase of a Bi-
Amp speaker measurement.
The confidence levels for individual drivers are given as each driver is measured, so if the
confidence (see Confidence in the Glossary of Terms) for the first driver is too low (less than 20
dB) you can halt the measurement, adjust the Master Volume, reduce ambient noise and/or
increase the number of sweeps, then repeat the measurement. When measurement is complete
without error, click Next.
If there are problems, go back, adjust levels and wiring, and repeat the steps until Measurement
completes successfully.
(This applies whether you are measuring a speaker for the first time or Verifying a Speaker
Correction.)