Installation guide

26
!"%%-,)&.'*7*+":?/#-7@-%!
Once a speaker measurement has been carried out, using the Measurement Wizard, a correction
filter can be generated for the speaker, using the Calibration Wizard. The correction filter is
designed to correct the following characteristics of the speaker:
The speaker’s change in gain or loudness over frequency (commonly known as its frequency-
response)
The speaker’s change in phase over frequency (commonly known as phase-response or Group
delay)
Note - if a pair of speakers is corrected together, the correction set created will match the phase-
response of the speakers, ensuring that the speakers are in phase when used. Consequently, if
you are planning to correct a pair of speakers, you should measure both speakers before using
the Calibration Wizard, then correct both speakers together.
To carry out a speaker correction, click on the Calibrate Speakers icon in the software. This will
start the Calibration Wizard.
The first window of the Calibration Wizard provides a brief introduction to the use of the wizard.
Click Next to continue.