Installation guide

34
results. You can use the four different profiles on the DEQX for comparisons. The best starting
point is to use the manufacturer's crossover frequencies. As a rule of thumb, do not cross-over to
a tweeter at frequency lower than 2Khz in the case of a 1” tweeter, and 3.5kHz in the case of a ¾”
tweeter.
3. Try varying the anechoic window cursor and the smoothing level to see how the frequency-
response is affected. If there are anomalies in the response this is a good place to experiment.
You can also disregard aspects of the measured response using the limits. You will soon get a
feel for how these all work together.
When you leave the Calibration Wizard (via the Finish button) it opens a window initially showing
preset Group Correction Delay parameters that can be adjusted, or accept the default settings
(refer to Speaker Calibration Parameters for more details).
Either enter a name or accept the default for the correction set.
Click Next to continue.