Installation guide

47
This will take you to the last dialog window and open the Configuration Window behind the
Configuration Wizard.
The last dialog window of the wizard provides tips on how to complete the configuration. Click
Finish to leave the Configuration Wizard.
Click Finish to Create the configuration.
Each configuration has 4 profiles, with default names as follows:
Profile 0
Profile 1
Profile 2
Profile 3
The profiles can be renamed and each profile can be different. For example, you may have
corrections of the same speakers with differing correction filters, and/or varying amounts of para
EQ cut/boost in different profiles, and even timing delays. However for any one configuration, all
four profiles must have the same mode (eg if you selected Tri-amp they will all be tri-amp). When
a new configuration is created, the speakers in all profiles are initially disabled.
The correction generated for a speaker using the Calibration Wizard can be placed in the
configuration.
For example, say you have generated a correction set for a left speaker and a right speaker and