Installation guide

The second window gives you the option of creating a new speaker calibration template or

loading an existing one. Select 'Load an existing speaker calibration' and click Next. This displays

a list of the speaker calibration formats (ie single amp, bi amp, tri amp and subwoofer) used by

existing speaker calibration templates. Click on the + sign next to the desired speaker calibration

format. This will display a list of all speaker calibration templates with that format. Check the box

next to the desired speaker calibration template, then click Finish.

The Calibration Wizard will close and the selected speaker calibration template will be opened in

a window, in the same way that a new calibration template is opened when correcting a speaker

for the first time (see Correcting a Loudspeaker).

Alternatively, and similar to speaker measurements, you can also view an existing speaker

calibration template by going through the Viewer icon.

<"=*)"*H/-*P*E"?&D$*7.*4N&/)&.'*!".D&':%7)&".*

Click on the Configure Icon . At the first window of the PDC Configuration Wizard, just click Next,

or, if you have more than one project loaded, select the project that contains the existing

configuration, then click Next.

At the second window of the Configuration Wizard, select the 'Load an existing PDC

configuration' radio button. This displays existing PDC configurations. Select the desired

configuration then click the Finish button.

<"=*)"*!"#$*I7%72-)%&,*45*A-))&.'/*D%"2*)(-*I3!*)"*7.*4N&/)&.'*!".D&':%7)&".;*

This enables you to retrieve any equalization that has been created using the Equalizer on the

PDC Control Panel onto an existing PDC Configuration.

Open the existing configuration using the instructions for How to Use / Modify an Existing

Configuration (see above).

Click on the Read EQ from PDC button. When the PDC Configuration is saved to disk using the

Save button, the equalization will also be saved.

How to Access Speaker Calibration Template(s) that were used in an Existing Configuration

Open the existing configuration using the instructions for How to Use / Modify an Existing

Configuration (see above).

The calibration templates used to create the filters in an existing PDC configuration can be

accessed from the Configuration view by clicking on the Open Template button . If the

configuration has been created from more than one template (ie if you have main speakers and

subwoofers in the configuration) then you will be asked to select which template is required.