Installation guide

84
Within the Speakers folder can be one or more ‘Speakers’. Each one of these Speakers
corresponds to a physical speaker plus the speaker configuration type, as per the example in the
figure above. The fifth ‘Speaker’ in the list above is a C&X brand speaker, model 916, serial
number 034193, in a single amp configuration.
It can be seen from the figure above that a physical speaker can have more than one type of
speaker configuration. There are four different speaker configurations: Tri amp, bi amp, single
amp and subwoofer. This enables you to measure a speaker as (for example) both a single
amped design, using the speaker’s own crossover, and as a bi amped design, using the PDC’s
crossovers.
Within each ‘Speaker’ are a Corrections folder and a Measurements folder. Within the
Measurements folder are the measurement(s) for that particular speaker / configuration pair.
Within the Corrections folder are the correction(s) (if any) created from any one of the
measurements in the Measurements folder.
From the Project Explorer, within the Speakers folder, the measurements and corrections may be
viewed by right-clicking on the individual measurements or corrections then choosing View.
(Note: Many menus are accessible by right-clicking.) The measurements cannot be opened (in
order to create new corrections) from within the Speakers folder. This can be done from the
Calibration Templates folder.