Installation guide

86
Calibrate / Analyze Measurement (refer to Correcting a Loudspeaker). Within each template are
two folders, one for the Measurements that have been used and one for the Correction Sets
created.
Within the Measurements folder are shortcuts to the speaker measurement(s) that have been
used.
Within the Correction Sets folder are the Correction Sets that have been generated using the
Calibration Wizard. Within each Correction Set is a Corrections folder and within that folder are
shortcuts to the corrections that have been generated, one correction for each measurement
used. A correction set is a set of correction filters. These correction filters have been created with
the same correction parameters.
It may be seen that, ultimately, the Speakers folder and the Calibration Templates folder both
provide access to the measurements and the corrections. However, the Speakers folder has a
structure that reflects the way in which the speakers were measured, whereas the Calibration
Templates folder has a structure that reflects the way in which groups of speakers were corrected.
Within the Calibration Templates folder, an individual template can be opened by right-clicking on
the template then choosing Open. Once the template is opened, new correction sets can be
generated from the measurements previously selected for the template.
S(-*L""2*E-7/:%-2-.)/*9"1?-%*
The Room Measurements folder has sub-folders as shown below