Installation guide

The Project Explorer showing a new project called Project 1

To open a closed folder, double click the folder icon or single-click the + button at its left. To close

an open folder, double click the folder or single-click the - button at its left.

Right click objects and folders to view a pop-up menu offering options specific to the object or

folder.

At the top of the Project Explorer is the Manufacturers and Microphones folder. Open the folder

to view the MANUFACTURERS and MICROPHONES folders. These folders contain

specifications and other general details on speakers and calibrated microphones, not specific to

audio system projects.

To add a microphone, click on the + sign next to the Manufacturers and Microphones folder, right

click on the MICROPHONE folder and chose Install from the pop-up menu.

Project folders appear below the Manufacturers and Microphones folder.

The Project Explorer can be used to access existing measurements, calibration templates, room

measurements and configurations.

To view a speaker measurement, open the relevant project. Navigate the Project Explorer by

selecting SPEAKERS, then the name of the speaker / measurement format (For example:

‘SuperSound/SS500/L (Single amp)’), then the MEASUREMENTS folder. Right-click on the

measurement then choose View from the pop-up menu.

To open a calibration template, open the relevant project. Navigate the Project Explorer by

selecting CALIBRATION TEMPLATES, then the name of the calibration template (For example:

TrebleKlef_Concerto_Bi amp_Measurement R (Bi amp)’). Right-click on the calibration template

then choose Open from the pop-up menu.

To view a room measurement, open the relevant project. Navigate the Project Explorer by

selecting ROOM MEASUREMENTS, then the name of the room, then MEASUREMENT

POSITIONS, then the name of the measurement position. Right-click on the measurement

position then choose View from the pop-up menu. This will open the room measurements for all

the speakers measured at that measurement position. You can also drag and drop the room

position measurements onto the Equalizer of the PDC Control Panel.

To open a configuration, open the relevant project. Navigate the Project Explorer by selecting

PDC CONFIGURATIONS, then the name of the configuration. Right-click on the configuration

then choose Open from the pop-up menu.

Copying and Pasting

Measurements, calibration templates and configurations can be copied between projects, using

the following procedure.