Installation guide

91
• Open the Project Explorer in the ‘View’ menu.
• Open the project you wish to insert data into (here on in called the destination).
• Go to the File menu, and select the ‘Insert Project’ option and select the project you wish
to import the data from (here on in called the source).
• Before trying to copy any other data, copy a 'PDC Configuration' from your source project
into the destination via 'drag and drop' in the 'Project Explorer'. This will copy over your
PDC profiles AND measurements. You cannot copy over any CORRECTION SET(s)
from source to destination; however, these can be recreated from the copied 'PDC
Configuration'.
• Click 'Configure PDC' and the 'PDC Configuration Wizard' will open.
• Select the destination project, click next, then 'Load an existing PDC configuration', and
select the PDC configuration we previously copied over and click 'Finish'.
• Select a speaker and click 'Open Template'. You will be told that no calibration templates
can be found and asked to recreate a template from the selected speaker. Click YES.
• Repeat the previous step for each speaker within the PDC configuration that uses a
different correction filter.
• Save the destination project.
G&-=-%*0&F7%?*
The viewer wizard can help you view existing speaker measurements, room measurements and
correction filters. Click the Viewer icon . This opens the Viewer Wizard.
At the first window of the Viewer Wizard, just click Next, or, if you have more than one project
loaded (as per the figure above), select the project that contains the existing measurement or
filter, then click Next.