Operation Manual

Settings programming

Note: HD2000 Urgence standard factory settings come

with:

- Programming access code = 0000

- Dialling = Tone

- Hook-Flash duration = 270 ms

- Pulse mark-break ratio = 66/33

- Access to memory programming =

unlocked

- Call barring = unlocked

To change settings, proceed as follows:

1) Make sure the telephone is connected to a powered

C.O. or PABX line.

2) Depress « PGR » key located on the small keypad

(Located at the back of the unit).

3) While keeping « PGR » key depressed, pick-up the

handset.

4) Release « PGR » key.

5) 2 sharp « beep » tones will confirm entering the

settings programming mode.

6) Enter the 4 digits programming access code with the

keypad (factory pre set code is: 0000)

This code can be modified (see « LIST OF

SETTINGS » section, pages 24-25).

7) If the right code is entered, 2 short « beep » tones

will be heard and the access to settings, changes will be

authorized.

If a wrong code is entered, a low « beep » tone will be

heard and the unit will return to talk mode.

8) Enter the 2 digits selected setting access code (see

« LIST OF SETTINGS » section pages 24-25)

9) 2 sharp « beep » tones confirming the selection will

be heard.

10) Enter your custom setting choice or the code or

number to store.

11) Terminate your setting by depressing « PGR » key.