User Manual

ManualsBrandsDerale Performance ManualsSensorsPremium Engine Spin On Adapter with -10AN O-ring Ports, 20x1.5mm Engine Thread

35703-35704-35706-35724-InstructionSheet

INSTALLATION INSTRUCTIONS

ENGINE SPIN-ON ADAPTER KIT

PART # 35703, 35704, 35706 & 35724

Derale Performance, Los Angeles, CA 800.421.6288 www.derale.com

Please read these instructions completely before beginning installation

INSTALLATION

VEHICLE TESTING

1. Remove the factory oil filter and clean the oil filter landing

surface on the engine block.

2. Take the Hex Sleeve Nut and slide it into the Spin-on Adapters

hex feature. Sleeve Nut will only install correctly in one direction.

(See Diagram #1)

3. Take the supplied Snap Ring and carefully install into the snap

ring groove of the casting making sure it is securely fastened.

(See Diagram #1)

4. Apply a light coat of oil onto the O-ring.

5. Take the O-ring and install into the groove on the Spin-On

Adapter.

6. Install onto the engine. (See Diagram #2)

7. Hand Tighten with the same force used in tightening a factory

oil filter.

When routing hoses, be sure to keep all hoses away from

sharp edges, moving parts and hot engine components.

Hoses should be routed carefully and should not be bent

in less than a 5” radius.

A kinked hose will restrict flow and could cause engine

failure.

1. Start the engine and quickly check all connections for leaks.

2. Turn-off the engine and check the oil.

3. Add oil as needed.

Warning:

Important:

Warning: Installation of accessories should only be undertaken by those with mechanical knowledge and are familiar with working on

vehicles. Always use eye protection (goggles, safety glasses or shield). Park the vehicle in a well lit area, on level ground and apply the

parking brake. Only work on a cold vehicle that has been sitting overnight, failure to do so will result in severe burns and injury. Before starting

the vehicle, make sure no tools or any other items are left under hood that could interfere with or be drawn into moving parts of the engine.

Failure to follow instructions can lead to severe damage and personal injury.

TOOLS NEEDED

Open End Wrenches

Oil Filter Wrench

KIT CONTENTS

QTY. DESCRIPTION

1 Spin-On Adapter

1 O-ring

1 Hex Sleeve Nut

1 Snap Ring

PART # THREAD SIZE

35703

35704

35706

35724

3/4”-16

18mm x 1.5

mm x 1.5

The purpose of a Spin-on Adapter is to provide external

oil lines for remote filter mounts and oil coolers.

Diagram #1

Snap

Ring

Hex Sleeve

Nut

Snap Ring

Groove

Diagram #2

Rev.-072011

Spin-On

Adapter

Spin-On

Adapter

O-ring

7/8-14”

O-ring Ports