Instruction manual

Shimano 7/8-speed shift lever
Turn the twistgrip to shift to all 8 (7) gears.
Increasing pedal force Indicator against 8 (7) Increasing pedal force Indicator against 8 (7)
Decreasing pedal force Indicator against 1 Decreasing pedal force Indicator against 1
Dismounting and mounting the rear wheel with Shimano hub
Removing the rear wheel
Removing the Shimano 3-speed hub gear shifter unit
Remove the shifter unit fixing screw. Remove the shifter unit from the hub.
Pull the shifter rod out of the hub axle.
Removing the Shimano 7/8-speed hub gear shifter unit
Remove the cable from the shifter unit in order to remove the rear wheel from the
frame. Before doing this, set the gear shift lever to 1st gear.
Pull the cable sheath out of the cable sheath holder and remove the cable from
the slot in the holder.
Remove the cable anchor screw
from the shifter wheel.
If it is difficult to pull the cable sheath
out of the holder in the shifter unit,
insert a 2 mm allen key in the hole of the
shifter wheel and turn the shifter wheel
to release the cable.
After this, first remove the cable anchor
screw from the shifter wheel before
pulling the cable sheath out of the cable
sheath holder.
Loosen and remove the screws from the brake arm.
Remove the wheel nuts and place them aside. Remove the safety washers
from the wheel axle.
Pull the rear wheel out of the slots in the dropouts.
Refitting the rear wheel
Place the chain on a rear sprocket and
position the hub axle in the dropouts.
Attach the safety washers on both sides
of the hub axle.
Indicator
Indicator
Revo twistgrip
CJ-8S20
JAPAN
LOCK
N
CJ-8S20
JAPAN
LOCK
remove
from the slot
pull out of
the cable
sheath holder
Holder
Slot
Cable sheath holder
CJ-8S20
JAPAN
2
1
CJ-8S20
JAPAN
LOCK
Cable anchor screw
Shifter wheel
2 mm allen key
or no. 14 spoke
shifter wheel hole
turn the
shifter wheel
pull out of
the cable sheath
holder
CJ-8S20
JAPAN
LOCK
3
1
Remove
the cable
anchor screw
2
18
Shifter unit
Hub axle
Dropout
DCW BedienA_GB UNI.qxd 24.10.2007 12:50 Uhr Seite 18