Instruction manual

➢ Turn the cable 60° to the right and
fix it to the hook.
➢ Attach the cable to the
shifter wheel as shown
in the illustration.
➢ Pull the cable through the
slot in the shifter unit holder
and push the end of the cable
sheath firmly into the cable
sheath holder.
➢ If it is easier, first insert the cable
sheath in the cable sheath holder,
insert a 2 mm allen key in the shifter
wheel hole and rotate the shifter
wheel in order to fit the cable anchor
screw correctly in the open side of
the shifter wheel.
CJ-8S20
JAPAN
LOCK
Turn
through 60 °
Hook
CJ-8S20
JAPAN
2
1
Slot
Cable sheath holder
Pull through
the slot.
Holder
Push into
the cable
sheath holder.
CJ-8S20
JAPAN
LOCK
Shifter wheel
Holder
Shifter cable
CJ-8S20
JAPAN
LOCK
1
2
3
Shifter wheel hole
Push into the cable
sheath holder
Insert
the cable
anchor screw
2 mm allen key
or no. 14 spoke
Rotate
the shifter
wheel
➢ Turn the crank arms and switch the Revo twistgrip two to three times from (3)
to (1) and back from (1) to (3) to check the shifting operation.
Set the Revo twistgrip to (2) and check that the red line on the rod is aligned
to the end of the hub axle.
If the alignment is incorrect,
you can perform fine adjustment
using the cable adjustment screw.
➢ After adjusting the angle lever, tighten the cable adjustment nut
to secure the cable adjustment screw.
Mounting the Shimano 7/8-speed hub gear shifter unit
➢ Attach the cable to the shifter wheel so that the cable fixing nut is directed
outwards towards the dropout and push the straight side of the intermediate
washer into the open side of the shifter wheel.
CJ-8S20
JAPAN
LOCK
Cable fixing nut
Shifter wheel
Open side of
the shifter wheel
Straight side of the
intermediate washer
SET
SET
Cable adjustment nut
21
english
françaisnederlands
español
DCW BedienA_GB UNI.qxd 24.10.2007 12:50 Uhr Seite 21