Wave 7 Rack • • • • U-lock compatible Parks 7 bicycles Easy installation 97% Recycled content Material 2” Sched.
Wave 7 Rack Installation 1. Place the rack in the desired location. Use a marker or pencil to outline the holes of the flange onto the base material. 2. Drill 3/8” diameter holes 3” deep into surface. Make sure the holes are at least 3” away from any cracks in the base material. 3. Place rack (and washers to level rack if necessary) over holes. 4. Thread nuts onto anchors, leaving approximately 1/4” of the anchor protruding, and tap into surface. Tighten nuts down to secure rack.
Wave 7 Rack In-Ground Installation Tools Needed Level Cement mixing tub Shovel Trowel Hole coring machine with 4” bit Access to water hose Installing into existing concrete Core holes no less than 3” diameter (4” recommended) and 10” deep into sidewalk. Fill holes with Por-Rok or epoxy grout. Place rack into holes, making sure the rack is level. 33”-36” of the rack should remain above the surface. If the rack is less than 33” high, it will not support the bike adequately.
