ROLLING RACK Setbacks 108" 24" 96" ST R 36" T © 2015 Dero T E RE ST EE www.dero.
ROLLING RACK Installation Instructions – Surface Mount TOOLS NEEDED RECOMMENDED BASE MATERIAL Tape Measure Marker or Pencil Masonry Drill Bit Drill (Hammer drill recommended) Hammer Wrench or ratchet 9/16” Level Solid concrete is the best base material for installation. To ensure the proper anchors are shipped with your rack, ask your Dero Rack representative which anchor is appropriate for your application. Be sure nothing is underneath the base material that could be damaged by drilling.
ROLLING RACK Installation Instructions – In Ground Mount TOOLS NEEDED Hole coring machine with 4” bit Access to water hose Materials to build brace (see “Install Tip” at bottom of page) Level Cement mixing tub Shovel Trowel Recommended hole diameter = 4” INSTALLING INTO EXISTING SIDEWALK Core holes no less than 3” diameter (4” recommended) and 10” deep into sidewalk. Place Rolling Rack into hole making sure the rack is level. Fill hole with Por-Rok or epoxy grout.
ROLLING RACK Installation Instructions – In Ground Mount 3 INSTALL TIP After appropriate cure time, dig out sand from sleeves and insert racks, making sure they are level and at the appropriate height. Pour in PorRok or epoxy grout and allow to set. An easy way to brace the Rolling Rack while the grout sets is to bolt two 1x4” boards together at one end and clamp them onto the legs of the rack like a clothes pin. Placing 2x4 blocks under the bottom curves will help to set the correct height. www.dero.
