Instructions / Assembly

www.dero.com | 1-888-337-6729
© 2015 Dero
96”
72”
48”
Approx.
4.25”
Mount 24” Slotted Tracks vertically to the wall with the appropriate anchors. Use a level for greatest accuracy.
The bottom edge of the Slotted Track should be approximately 72” o the floor. The Slotted Tracks should be
4’ apart from each other, and the end Slotted Tracks should be 2’ from the eventual position of the end of the
Trolley track.
Mount the remaining 24” Slotted Tracks horizontally and protruding from the wall so that the slotted surface of
the Slotted Track is 4.25” below the top edge of the vertical 24” Slotted Track. Use the Knee Braces, Angle
Brackets, and the Spring-loaded Nuts and Hex Head Cap Screws to secure the horizontal Slotted Track in
place.
1
2
BEFORE INSTALLING
Solid concrete is the best base material. Brick, block, and wood
stud walls may be acceptable. Metal stud walls are not an
acceptable material for installation. Before installing make sure
nothing is behind the wall that could be damaged by drilling and
that the base material is strong enough to support a fully loaded
rack. Tell your Dero representative what kind of base material you
are installing the Track Rack into so the proper anchors can be
shipped with the rack.
TOOLS NEEDED
9/16” Wrench/Socket
3/4” Wrench/Socket
1/4” Drill Bit or 3/8” Masonry Drill Bit
(depending on anchor type)
Tape Measure
Drill (Hammer Drill Recommended)
Hammer
Level
Saw for cutting rack
TRACK RACK
Installation Instructions – Wall Mount