GFP28BK Brick Liner Kit Installation Instructions
GFP28BK Brick Liner Kit Installation Instructions IMPORTANT: Read entire instruction sheet before installing brick liner. This brick liner accessory is approved for use in the following models: GFP28MNG, GFP28MLP, GFP28TNG, and GFP28TLP. Do not use brick liner accessory in any other fireplace models.
. With larger bricks at the top, install rear firebrick panel on back wall first. Rest the bottom edge of firebrick panel on liner flange. Stand firebrick panel straight up against the back of fireplace (see Figure 3). Back Wall Hole for Retainer Bracket Screw (remove existing screw, if any) Retainer Bracket Screw WARNING ICON G 001 CAUTION Always handle firebrick panels with two hands. Do not force firebrick panels into place. Excessive force will break firebrick panels.
6. Secure side firebrick panel to side wall of fireplace with one retainer bracket and one screw (see Figure 6). Note: If there is a screw in the fireplace side walls where 8. Put log base assembly back into fireplace. Secure log base assembly with the two screws removed in step 2 (see Figure 2, page 2). you are to install the retaining bracket, remove screw. WARNING ICON Retainer Bracket Screw G 001 WARNING A qualified service person must connect and disconnect fireplace to gas supply.
