OPERATING INSTRUCTIONS AND OWNER’S MANUAL Model # SPC-500 READ INSTRUCTIONS CAREFULLY: Read and follow all instructions. Place instructions in a safe place for future reference. Do not allow anyone who has not read these instructions to assemble, light, adjust or operate this tool.
FOR YOUR SAFETY! Read and understand instructions before use! Retain this information for future reference. If you smell gas: (Under certain conditions odor may fade (Refer to page 6) - Shut off gas to the device. - DO NOT try to light appliance. - Extinguish any open flame. - Check the device for leaks using soapy water. - DO NOT attempt to relight the device until all leaks are repaired and there is no gas smell.
SPC-500-Parts List 1 2 3 ITEM DESCRIPTION PART NO. 1 ....................... Handle Assembly ........... 72601 2 ....................... Hose Assembly .............. 72602 3 ....................... Striker ........................... 72603 When ordering repair parts, always furnish the following information: 1) Model Number 2) Part Number 3) Part Description CAUTION: Use only genuine SCHEU PRODUCTS replacement parts. Never substitute parts. Do not use modified parts.
OPERATING CHARACTERISTICS Model SPC-500 BTU Operating Temperature Range Inlet Pressure Range 500,000* -10o F to 100o F 17 psi to 170 psi * Tank size and tank temperature can directly affect BTU output Assembly Instructions: Assembled Un-assembled 1) Unpack all the components and inspect for any damage. If any damage is discovered contact the delivery service or Scheu Products immediately. 2) Connect the hose assembly to the handle assembly and tighten counterclockwise.
HOT SHOT Model SPC 500 Assembly, Testing & Operating Instructions SCHEU PRODUCTS COMPANY CAUTION: DO NOT operate if any leaks are present. A leak may create a fire hazard. DO NOT smoke around or expose supply tank(s) to open flames or sparks. DO NOT apply heat or flame to tank to check for leaks. Excess heat may cause the supply tank to rupture, possibly causing personal injury. Lighting Instructions: NOTE: The hose assembly is supplied with an excess flow control valve.
ODOR FADE WARNING WARNING Asphyxiation Hazard • Do not use this heater for heating human living quarters. • Do not use in unventilated areas. • The flow of combustion and ventilation air must not be obstructed. • Proper ventilation air must be provided to support the combustion air requirements of the heater being used. • Refer to the specification section of the heater’s manual, heater dataplate, or contact the Scheu Products Company to determine combustion air ventilation requirements of the heater.
CAUTION: DO NOT smoke around or expose supply tank(s) to open flame or sparks. Always use the striker provided. Never use a match or lighter to ignite torch. Use of device other than the striker may cause personal injury. DO NOT place hand or any body part in the path of the flame while lighting or operating torch. This can result in personal injury. Shut-Off Instructions: 1) 2) 3) the hose. Close torch adjusting valve. Close supply tank shut-off valve.
CAUTION: DO NOT smoke around or expose supply tank(s) to open flames or sparks. Storage: Never store a torch that is still hot. When the torch is stored indoors, the connection between the LP gas tank(s) and the device must be disconnected and the tank(s) removed from the device and stored outdoors in accordance with Chapter 5 of the “Standard for the Storage and Handling of Liquefied Petroleum Gases” ANSI/NFPA 58. CAUTION: DO NOT smoke around or expose supply tank(s) to open flame or sparks.
OPERATING INSTRUCTIONS AND OWNER’S MANUAL Model # SPC 500 WARNING: USE ONLY MANUFACTURER’S REPLACEMENTPARTS. USE OFANY OTHER PARTS COULD CAUSE INJURY OR DEATH. REPLACEMENT PARTSARE ONLYAVAILABLE DIRECT FROM THE FACTORYAND MUST BE INSTALLED BYA QUALIFIED SERVICE AGENCY. PARTS ORDERING INFORMATION: PURCHASING: Accessories may be purchased at any Scheu Products Co. local dealer or direct from the factory FOR INFORMATION REGARDING SERVICE Please call Toll-Free 800-325-7057 www.allpro-heaters.
