Owner's Manual

www.desatech.com
111244-01G24
OPERATING FIREPLACE
Continued
Note:Itissafetooperatereplacewithblower
turned off. However, the blower helps distribute
heatedairfromthereplace.
Figure 44 - AUTO/OFF/ON Blower Switch
AUTO/OFF/ON Switch
REMOTE-READY MODELS
FOR YOUR SAFETY
READ BEFORE LIGHTING
WARNING: If you do not fol-
low these instructions exactly,
     
-

A. This appliance has a pilot which must be
lighted by hand. When lighting the pilot,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the
appliance area for gas. Be sure to smell next
totheoorbecausesomegasisheavierthan
airandwillsettleontheoor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building.
• Immediately call your gas supplier from
a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call
theredepartment.
C. Use only your hand to push in or turn the
gas control knob. Never use tools. If the
knob will not push in or turn by hand, don’t
trytorepairit,callaqualiedservicetech-
nician or gas supplier. Force or attempted
repairmayresultinareorexplosion.
D. Do not use this appliance if any part has been
underwater.Immediatelycallaqualiedser-
vice technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
LIGHTING
INSTRUCTIONS
WARNING: You must operate
     


   -
    
-

    
   

WARNING: Burner will come
on automatically within one min-
ute when control valve is in the ON

1. STOP! Read the safety information starting
in column 1.
2. Make sure equipment shutoff valve is fully
open.
3. Press in and turn control knob clockwise
totheOFFposition(seeFigure44).
4. Waitve(5)minutestoclearoutanygas.
Thensmellforgas,includingneartheoor.
If you smell gas, STOP! Follow “B” in the
safety information, column 1. If you don’t
smell gas, go to the next step.
5. Press in and turn control knob counter-
clockwise to the PILOT position.
Pressincontrolknobforve(5)seconds
(seeFigure45).
Note:Youmayberunningthisreplacefor
thersttimeafterhookinguptogassup-
ply. If so, the control knob may need to be
pressed in for 30 seconds or more. This will
allow air to bleed from the gas system.
Figure 45 - Control Knob and Ignitor
Button Location (Shown as Supplied
- No Control Options)
Piezo
Ignitor
Button
Control
Knob
Flame
Adjustment
Knob