Owner's Manual

www.desatech.com
111244-01G 25
OPERATING FIREPLACE
Continued
6. With control knob pressed in, press and
release ignitor button. This will light pilot.
The pilot is attached to the front burner. If
needed, keep pressing ignitor button until
pilot lights.
Note: If pilot does not stay lit, contact a
qualiedservicepersonorgassupplierfor
repairs. Until repairs are made, light pilot
with match. To light pilot with match, see
Manual Lighting Procedure.
7. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob.
• If control knob does not pop out when
released,contactaqualiedserviceperson
or gas supplier for repairs.
Note: If pilot goes out, repeat steps 4
through 8.
8. Slightly push in and turn control knob coun-
terclockwise to the ON position.
9. Set ame adjustment knob to any level
between HI and LO.
CAUTION: Do not try to ad-


Figure 46 - Propane/LP Gas Pilot
Ignitor
Electrode
Pilot
Burner
Figure 47 - Natural Gas Pilot
Ignitor
Electrode
Pilot Burner
TO TURN OFF GAS


1. Turn control knob clockwise to the
OFF position.
2. 
Set selector switch in the OFF position to
prevent draining battery.

You may shut off the burners and keep the pilot
lit by doing one of the following:
1. Turn control knob clockwise to the
PILOT position.
2. If Using Optional Hand-Held Remote: Use
remote control manual OFF button.
WARNING: Make sure remote
sensor selector switch is in the
OFF position when you are away


MANUAL LIGHTING

1. Follow steps1 through 5 under Lighting
Instructions, page 24.
2. Depress control knob and light pilot with
match.
3. Keep control knob pressed in for 30 seconds
after lighting pilot. After 30 seconds, release
control knob. Now follow steps 8 and 9
under Lighting Instructions, column 1.


Note: All remote control accessories must be
purchasedseparately(seeAccessories,page44).
Follow instructions included with the remote
control.

-
Lighting
Instructions
Afterlighting, let pilot ameburn forabout
one minute. Turn control knob to ON position.
Adjust ame adjustment knob anywherebe-
tween HI and LO. Slide the selector switch to
theREMOTEposition(seeFigure48,page26).